Alliance Laundry Systems Washer-Extractors SCA

Inspect the door interlock before starting operation

Is the door lock and interlock functioning properly?

Check the machine for leaks by starting an unloaded cycle to fill the machine

Verify the following during the leak check

Inspect the water inlet valve hose connections on the back of the machine for leaks

Inspect the chemical connections for leaks or cracks

Inspect the steam hose connections for leaks, if applicable

Ensure all panels and guards are properly installed

Remove dirt and grease with detergent and water.

Thoroughly rinse and dry after washing.

Avoid contact with dissimilar metals to prevent galvanic corrosion.

Wipe clean any salty or acidic residues.

Rub in the direction of the polish lines or 'grain' of the stainless steel.

Disconnect power to the machine at its source before performing maintenance procedures.

Inspect all hose, drain, and overflow connections/clamps for leaks and visible signs of deterioration. Replace as necessary.

Inspect the belt for unusual wear, frayed edges, and improper belt tension. Replace belts and/or adjust tensioning elements as necessary.

Determine if belt(s) require replacement or adjustment using the following methods. Call a qualified service technician if necessary.

Verify the belt is centered on the basket pulley within the specified limits for the model.

Disconnect the electrical power to washer-extractor before examining the wiring.

Electrical Connections Inspection

Inspect the electrical connections for looseness.

Is the insulation intact on all external wires and all connections secure?

If bare wire is evident, call a service technician and describe the issue.

Inlet Hose Filter Screens Cleaning

Turn water off and allow valve and water line to cool, if necessary.

Unscrew inlet hose from the faucet and remove filter screen.