Agilent Pump G7112B

NOTE: The figures shown in this procedure exemplarily show the Infinity III Vialsampler module. The principle of how to remove and/or install doors works in the same way for all Infinity III modules.

Press the release buttons and pull the front door out.

For the Installation of the front door, insert the hinges into their guides and push the door in until the release buttons click into their final position.

Press the Leak Adapter down and remove it together with the tubing

Install the Leak Adapter by pressing it into the Main Cover

Insert the Tubing (approximately 85 mm required for replacement) between Leak Adapter outlet and Leak Panel

System requirements: Lab Advisor B.02.08, Firmware D.07.01

Choose the solvent for the test

Enter the target pressure for the test

Air bubbles removed from the pump?

Enter the initial pressure (100 bar below target)

Piston 1 brought to its rear position?

Enter the flow rate delivered by piston 1

Enter the minimum pressure of the curve segment for piston 1

Piston 2 moved to its rear position?

Warning: Liquid dripping into the electronic compartment of your module can cause shock hazard and damage the module

Note: A solution of 70 % isopropanol and 30 % water might be used if the surface of the module needs to be disinfected.

Did you use a soft cloth slightly dampened with water, or a solution of water and mild detergent?

Did you avoid using organic solvents for cleaning purposes?

Did you ensure not to use an excessively damp cloth during cleaning?

Did you drain all solvent lines before opening any connections in the flow path?

Sign off on the module cleaning

Warning: Read update documentation provided with the Firmware Update Tool before proceeding.

Choose the reason for firmware replacement

Upload the required module firmware

Upload the latest FW Update Tool

Upload the documentation from the Agilent web

Instructions followed for loading the firmware into the module

Sign off on the firmware replacement