Vulcan Heavy Duty Gas Griddle MSA60

WARNING! All gas joints disturbed during servicing must be checked for leaks. Check with a soap and water solution (bubbles). Do not use an open flame

Turn the gas supply off at a manual shutoff valve

Remove the pressure tap plug and attach manometer

Turn all thermostats on to the maximum setting so that all burners are on

Turn all the equipment on the same supply line on

Ensure the following conditions are met for the regulator installation

Check that the vent plug is not clogged by grease and debris

Enter the gas pressure after the regulator is installed

Is the gas pressure set correctly for the type of gas used?

Enter the supply pressure (upstream of the regulator)

Is the supply pressure within the acceptable range?

Disconnect the electrical power to the machine and follow lockout / tagout procedures

Shut off the gas before servicing the unit and follow lockout / tagout procedures

Remove screw securing pilot assembly bracket from underneath the front of the griddle

Disengage bracket from slot and work assembly down to access parts

Align pilot with flash tube opening and verify 1/8” gap between the end of flash tube and burner on both sides

Service assembly as required and reassemble ensuring bracket is seated in slot for alignment

WARNING! Disconnect the electrical power to the machine and follow lockout / tagout procedures

Push tab to release igniter from frame and pull out of unit

Label and disconnect wires from electric igniter

Install igniter in reverse order

Check that all parts are reassembled correctly

Test the machine to ensure proper operation

Describe any issues encountered during the replacement

Disconnect the electrical power to the machine and follow lockout / tagout procedures

Shut off the gas before servicing the unit and follow lockout / tagout procedures

Measure distance between manifold pipe and valve for reassembly later

Disconnect all gas lines and thermocouple from valve

Transfer fittings from old valve to new valve