Sullair Industrial Air Compressor TSR-20_125XH

Warning: This maintenance check requires trained personnel with PPE!

Protective grill removed from the adapter housing

Retaining screw located on the outer sleeve loosened

Coupling element unwrapped from the coupling jaws

New element installed by wrapping it around the jaws

Outer sleeve reinstalled and secured by tightening the two screws to 45 in·lbs (5 Nm)

Warning: Ensure the compressor is turned off and cooled down before performing any maintenance tasks.

Sign off on the initial 50 hours compressor maintenance

Warning: This maintenance check requires trained personnel with PPE!

Is the strainer screen damaged?

If the strainer screen is damaged, the strainer assembly must be replaced (406480) or order repair kit (250031-271).

Sign off on the water condensate drain maintenance

Replace the fluid filter element under any of the following conditions

FLUID FILTER ELEMENT REPLACEMENT

Use a wrench to remove the filter canister

Remove and dispose of filter element properly

Note! Dispose of fluids in accordance with applicable federal, state and local regulations

Apply a light film of fluid to the element seal

Install the element into the filter canister

Replace the fluid filter element

Sign off on the 2000 hourly compressor maintenance