Stryker Stretcher 1460

Grip the push handles with two hands.

Remove the brake/go pedal assembly. Save all parts.

Manually open the brake fingers. Manually rotate the rear wheel shaft assembly so the socket head cap screws face the bottom of the chair.

Loosen the two socket head cap screws on the rear wheel shaft assembly using a 9/64” hex wrench.

Remove the retaining ring that secures the rear wheel shaft assembly on the chair frame using snap ring pliers. Save the retaining ring.

Remove the rear wheel shaft assembly.

Remove the screws and brake finger spacer nuts that secure the brake finger assembly using a 5/32” hex wrench and a 3/16” hex wrench. When reinstalling the screws, use a 3/8” drive torque wrench to torque the screws to 70 ± 10 in-lb.

Remove and discard the brake finger assembly.

Reverse steps 2-7 to install the supplied brake finger assembly.

Replace the brake/go pedal assembly.

Upload a photo of the removed seat back

Number of button head cap screws removed

Chart holder removed from the lower chair frame

Chart holder removed from the upper chair frame

Supplied chart holder installed

Sign off on the chart holder replacement

Follow the cleaning solution manufacturer’s dilution recommendations exactly.

Hand-wash all surfaces of the product with a recommended disinfectant between uses.

Apply the recommended disinfectant solution by spray or pre-soaked wipes.

Disinfect all surfaces. Pay attention to high contact areas, such as the flip-up armrest, seat, seat back, push handles, and optional oxygen bottle holder.

Follow the cleaning solution manufacturer’s instructions for appropriate contact time and rinsing requirements.

Dry the product thoroughly before returning the product to service.

Sign off on the cleaning method

Put the flip-up armrest in the forward and locked position

Using a 5/16” hex wrench, remove the hard stop pin (A) from the bottom of the flip-up armrest

Using one hand, pull up on the armrest release pin (B) and use your other hand to pull outward on the flip-up armrest (C) to remove the armrest

Grease the supplied armrest pivot with Syntec grease (3000-200-719)

Pulling upward on the armrest release pin, install the supplied flip-up armrest onto the chair frame

Using a 5/16” hex wrench, install the supplied hard stop pin (removed in step 2). Using a 3/8” drive torque wrench, torque the hard stop pin to 33 ± 7 ft-lb

Verify proper operation before returning the product to service

Sign off on the armrest replacement