Stryker Stretcher 4402

Product raised a few inches off the floor using a small jack

Two screws and two washers removed using a 5/32” hex t-handle

Repeat of step 1 and step 2 on the opposite end of the product

Entire column assembly raised off of the base assembly with the help of a second person

Assembly set securely out of the way

Base cover removed and discarded

Small jack used near the caster to be replaced

Bolt and caster assembly removed from the base weldment using a 3/8” drive ratchet and 5/16” hex driver

Installation done in reverse order

Proper operation verified before returning the product to service

Sign off on the caster replacement

Remove the eight screws that secure the column and drawer assembly to the top cradle bracket

Remove the four screws that secure both columns to each valance bracket

Remove the two screws that secure each release handle to the top cradle bracket

Remove the four screws and washers from each cylinder bracket that secure the cylinder to the top cradle bracket

Strike the top cradle bracket, near the cylinder to disengage the bracket from the cylinder top

Flip the top assembly upside down

Remove the six screws and washers that secure the two valance brackets

Basket removed from the product

Two yellow basket pivot pins removed using a 3/16” hex wrench

Accessed the nuts that secure the basket trend catch to the top cover

Two nuts that secure the trend catch removed using a 3/8” nut driver

Both sides of the top cover cradle grasped and pulled up until the bottom and the top cover Velcro® separate

Cradle top cover removed and discarded

Proper operation verified before returning the product to service

Two screws securing the drawer slide to the drawer removed using a T10 Torx driver and 5/16” wrench

Screw (E) and washer (F) securing the drawer slide to the column removed using a T15 Torx driver

Drawer opened from the opposite side and step 4 repeated

Drawer slide tab pulled out of the drawer from the open drawer

Drawer opened from the opposite side and step 6 repeated

Entire drawer slide assembly removed and discarded

Drawer slide assembly installed in reverse order