Stryker Stretcher 6091 EX-PRO 2 ambulance Cot

Pole lifted and pivoted from the storage position and pushed down until it is locked into receptacle (A)

Lock actuator (B) turned counterclockwise and telescoping portion (C) of the pole pulled up to raise it to the desired height

Lock actuator (B) turned clockwise to lock the telescoping portion in place

I.V. bags hanged on the I.V. hook (D)

Sign off on the I.V. Pole Maintenance

Pole lifted and pivoted from the storage position and pushed down until it is locked into receptacle (A)

Height of the pole raised by turning the lock actuator (B) counterclockwise and pulling up on the bottom telescoping portion (C) of the pole

Lock actuator (B) turned clockwise to lock the bottom telescoping portion in place

For a higher I.V. pole, section (D) pulled up until the spring clip (E) engages

I.V. bags hanged on the I.V. hook (F)

To lower the I.V. pole, spring clip (E) pushed in and section (D) slid down into section (C). Lock actuator (B) turned counterclockwise and section (C) slid into the bottom tube

Pole lifted up and pivoted down into the storage position

Sign off on the I.V. pole maintenance

Apply the stick wax to the inner surface of the black c–channel

Cover the entire surface between the oblong holes with a thin, even film of wax

Ensure there are no thick areas of wax

Repeat the wax application for the c–channel on the other side of the cot

Cycle the cot through all its positions two or three times

Ensure adequate application of the wax

Sign off on the C–Channel Wax Maintenance

Remove the bolt (G) and disconnect link (B)

Lift the cot at both ends to take the weight off the base frame. Pull the foot end release handle and verify the patient left latch bar (C) is touching the foot end lever support bracket (E) at contact point 1

If the handle requires adjustment, remove the bolt (F), turn the rod end (H), and replace the bolt (F) until the conditions described in step 1 are achieved. Verify there is approximately 1/8” of clearance between the release handle and the grip on the lift bar

Replace bolt (G) to reconnect link (B)

Lift the cot at both ends to take the weight off the base frame. Pull the foot end release handle and verify the patient right latch bar (D) is touching the foot end lever support bracket (E) , at contact point 2. Verify the patient left latch bar (C) is touching the foot end lever support bracket (E) at contact point 1. Verify there is approximately 1/8” of clearance between the release handle and the grip on the lift bar

If the handle requires adjustment, remove the bolt (G),turn the rod end (H), and replace the bolt (F) until the conditions described in step 6 are achieved.

Sign off on the handle adjustment

Select the frequency of cot inspection

Upload a photo of the cot after inspection