Stryker Stretcher 6092 EZ-Pro

Lift and pivot the pole from the storage position and push down until it is locked into receptacle (A)

Turn the lock actuator (B) counterclockwise and pull up on the bottom telescoping portion (C) of the pole to raise it to the desired height

Turn the lock actuator (B) clockwise to lock the bottom telescoping portion in place

For a higher I.V. pole, pull up on section (D) until the spring clip (E) engages

Hang I.V. bags on the I.V. hook (F)

To lower the I.V. pole, push in on the spring clip (E) and slide section (D) down into section (C). Turn the lock actuator (B) counterclockwise and slide section (C) into the bottom tube

Lift up and pivot the pole down into the storage position

Sign off on the I.V. pole maintenance

Auxiliary lock release link (B) pulled and held

Auxiliary lock lever (C) bottomed in the slot of the lever guard (D)

Hole in the rod end (E) aligned with the weld nut in the auxiliary lock slide link (F)

Sign off on the auxiliary lock handle adjustment

All fasteners secure (reference all assembly prints)

All welds intact, not cracked or broken

No bent or broken tubing or sheet metal

All wheels secure, rolling and swivelling properly

Optional wheel lock holds wheel securely when on and clears wheel when off

Siderails move and latch properly

Optional accessories intact and operating properly

Changing From the Loading to the Folded Position

Two operators stand at opposite ends of the cot and grasp the litter frame with palms facing up

The foot end operator unlocks the cot’s auxiliary lock

Both operators lift the cot until the weight is off the latching mechanism

The foot end operator squeezes and holds the release handle and both operators lower the cot to the folded position

Lowering the Cot from the Load Position to an Intermediate Transport Position

Two operators firmly grasp the litter frame at opposite ends with palms facing up

The foot end operator unlocks the auxiliary lock

Both operators lift the cot until the weight is off the latching mechanism

Remove the bolt (G) and disconnect the link (B)

Lift the cot at both ends to take the weight off the base frame. Pull the foot end release handle and verify the patient left latch bar (C) is touching the foot end lever support bracket (E) at contact point 1

If the handle requires adjustment, remove the bolt (F), turn the rod end (H), and replace the bolt (F) until the conditions described in step 1 are achieved. Verify there is approximately 1/8” of clearance between the release handle and the grip on the lift bar

Replace bolt (G) to reconnect link (B)

Lift the cot at both ends to take the weight off the base frame. Pull the foot end release handle and verify the patient right latch bar (D) is touching the foot end lever support bracket (E) , at contact point 2. Verify the patient left latch bar (C) is touching the foot end lever support bracket (E) at contact point 1. Verify there is approximately 1/8” of clearance between the release handle and the grip on the lift bar

If the handle requires adjustment, remove the bolt (G),turn the rod end (H), and replace the bolt (G) until the conditions described in step 5 are achieved.

Sign off on the handle adjustment