Stryker Stretcher 3333

Apply the brake on the recliner casters located opposite the side you need to replace.

Using a rubber mallet, tap the back of the arm cap to move it forward until it becomes loose.

Align new arm cap fasteners over slot.

Using a rubber mallet, tap the arm cap from the front until flush.

Using a rubber mallet, tap the top of the arm in a downward motion to secure it to the arm frame.

Check proper functionality of the arm cap prior to returning the recliner to service.

Slide the backrest cushion over the recline mechanism

Insert the sleeves on the backrest onto the posts

Align the threaded hole on the sleeve with the elongated hole on the post

Insert the threaded screw knob into the elongated hole

Tighten the screw knob on both sides of the backrest

Check proper functionality of the recliner

Lift the fabric flap and locate the screw knob on both sides of the recliner

Apply the brake on the recliner casters located opposite the side you need to replace

Carefully tip the recliner while pivoting on the locked casters and lay on its side

Using a #3 Phillips screwdriver, remove the four screws that secure the caster to the chair frame

Using a #3 Phillips screwdriver, secure the new caster to the chair frame with the four screws removed in step 3

Flip chair upright using caution not to drop chair

Release the brake on all casters

Check proper functionality of the caster prior to returning the recliner to service

Measure 4-3/8” from the top seam and 2-7/8” from the side seam of the backrest

Prick the fabric to find the hole for the screw on both sides

Locate the push bar onto the backrest with the bumpers oriented upwards

Install the top two screws without fully tightening so that the bracket is loose on both sides

Make sure that the bracket are square with the chair, use a scribe to pilot the bottom two holes

Install the two screws into the bottom holes and tighten. Also tighten the top two screws

Check proper functionality of the recliner prior to returning the recliner to service

Sign off on the push bar replacement

Brake applied on the recliner casters

Two 7/16” bolts removed from the foot tray slide tubes

Proper functionality of the new foot tray assembly checked

Sign off on the foot tray assembly replacement