Southbend Range 436A-3G

Loosen screw and rotate mixer cap until a clear, stable blue flame is obtained.

Is the flame free of yellow tips and not blowing off the burner ports?

Remove the front panel below the oven door to access the pilot line valve.

Adjust the standing oven pilot flame using the adjusting screw on the pilot line valve.

Is the pilot flame just large enough to maintain a glowing red color of the flame switch capillary bulb?

Adjust the primary air mixer cap to achieve a clear blue flame with a distinct inner cone at each port.

Clean around burner air mixers and orifices if lint has accumulated

Visually assure proper pilot operation

Inspect the vent system for any visible damage or wear

Is there any corrosion present on the vent system?

Clean the vent system thoroughly to remove any dust or debris

Was a more thorough cleaning required due to climatic conditions?

Ensure all parts are securely reassembled after cleaning

Verify that the following parts are in place after cleaning

Remove, empty, and clean components

Ensure oven by-pass flame has been adjusted

Select temperature measurement tool

Place thermocouple or thermometer in the middle of the oven

Temperature Check at 400 Degrees

Remove dial and push out metal insert

Replace dial and turn to 400 mark