Schneider Electric Pressure Transmitter IDP10S-F

De-energize transmitters before removing threaded housing covers

Ensure no flammable or combustible atmosphere is present before disconnecting equipment

Remove the vent plug by unscrewing it counterclockwise

Clean the angled sealing surface on the housing

Lubricate the o-ring and the threads on the new plug with silicone lubricant

Install the new plug into the housing by screwing it clockwise

Torque the new plug to 0.9 ±0.02 N-m (8 ±0.2 lbf-in)

Verify the torque applied to the new plug

Is the FoxCalTM feature enabled?

Ensure the transmitter is stabilized at the final operating temperature.

Perform two-point calibration if FoxCalTM is enabled

Rezero the transmitter output to eliminate zero shifts from position effects.

Check if underrange and overrange output values extend beyond 4 and 20 mA, respectively.

Zero Reading Check (DP Transmitters Only)

Return the output to linear mode for zero reading check.

View the total days the transmitter has been in service using the 1 Device Setup > 2 Calibration > Time in Service Meter menu selection.

View the user days since the last reset using the 1 Device Setup > 2 Calibration > Reset User Days menu selection.

Reset the user days to zero using the 1 Device Setup > 2 Calibration > Reset User Days menu selection.

Perform a two-point calibration if FoxCalTM is enabled.

Rezero the transmitter output once it has stabilized at the final operating temperature.

Check underrange and overrange output values to ensure they extend beyond 4 and 20 mA, respectively.

Is the FoxCalTM feature enabled?

Perform One-Point Calibration at LRV

Perform one-point offset calibration at LRV

Is the transmitter output stabilized at the final operating temperature?

Rezero the transmitter output if necessary

Are underrange and overrange output values extending beyond 4 and 20 mA?

Ensure required tools are available

Follow the required protocol to remove the device from online operation

Override the milliamp output to the High Failsafe setting

Confirm the mA output corresponds to 21.0 mA

Override the milliamp output to the Low Failsafe setting

Confirm the mA output corresponds to 3.6 mA