Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Nordson Bulk Melter 7407040

Create an account to install this asset package.

Maintenance Plans for Nordson Bulk Melter Model 7407040

Integrate maintenance plans directly into your work orders in MaintainX.

15000 Hourly / 2 Yearly Motor and Gear Box Lubricant Change

Warning: Only trained personnel should perform this procedure

Drain lubricant when warm

Use only the stated lubricant or one that has proven to be equivalent

Using any other lubricant can result in premature wear and/or damage to the gear box

Properly dispose of the old lubricant according to local regulations

Remove gear box from the motor to change lubricant

Wash out casing with suitable cleaning agent and remove lubricant residue

Lubricant Changing Interval: Every 15000 hours of operation or at least every 2 to 3 years

Capacity: The lubricant quantity is indicated on the ID plate

Run this procedure

1 Daily Fan And Air Filter Maintenance

Depending on dust accumulation, the air filters in the fan and for the air outlet must be cleaned (knocked out) or replaced.

Refer to separate document Parts for filter order numbers.

Is dust accumulation severe?

Daily Maintenance Tasks

Sign off on the daily fan and air filter maintenance

Run this procedure

1 Daily Melter Cleaning

CAUTION: Observe the unit’s Degree of Protection when cleaning. Refer to page 12-3, Electrical Data.

CAUTION: Do not damage or remove safety labels. Damaged or removed safety labels must be replaced by new ones.

Material residue removed with a recommended cleaning agent?

Dust, flakes etc. removed with a vacuum cleaner or a soft cloth?

Motor / gear box: Clean fan cover?

Sign off on the daily melter cleaning

Run this procedure

1 Daily Melter Inspection

WARNING!: When damaged parts endanger the operating safety and/or the safety of personnel, switch off the bulk melter and have the damaged parts replaced by qualified personnel. Use only original Nordson spare parts.

Inspect for damage Power Cable

Inspect for damage Air Hoses

Sign off on the daily melter inspection

Run this procedure

1 Monthly Melter Maintenance

Warning: This maintenance check requires trained personnel with PPE!

Re-tighten the following components with a torque wrench while the material is still soft (approx. 70 ° C/158 ° F, depending on the material)

Plug, A tightened

Hose Fitting, A tightened

Re-tighten the following components crosswise

Pump: Fixing screws, A, B tightened

Safety valve, A tightened