Hyster-Yale Chain Hoist 2,0t/2

Warning: This inspection requires trained personnel with PPE!

Supporting structure has sufficient stability

Expected forces can be safely absorbed

Issues found during the inspection

Sign off on the attachment point inspection

Warning: This inspection requires trained personnel with PPE!

Supporting structure has sufficient stability

Expected forces can be safely absorbed

Issues found during the inspection

Sign off on the attachment point inspection

Warning: This procedure requires trained personnel!

Lift, pull or tension and lower or release a load over a short distance with the unit

When the hand chain is released, the load must be held in any position

Repeat the above steps at least twice

Did the brake function properly?

ATTENTION: If the brake does not function properly, the unit must be immediately taken out of service and the manufacturer must be contacted!

Sign off on the brake function check

Warning: This inspection requires trained personnel with PPE!

Load chain is not twisted or kinked

Did the bottom block roll over?

Load chains approved by the manufacturer

Sign off on the chain reeving inspection

Warning: For safety reasons, hand chain links may only be used once.

Is the distance of the lower end to the floor between 500 – 1000 mm?

Look for the non-welded link of the hand chain, bend to open and discard it.

Did you shorten or extend the chain to the required length?

ATTENTION: Always remove or add an even number of chain links.

Did you use a new link to close the loose chain ends by bending it?

For extending the hand chain, two new chain links are required.

Did you make sure that hand chains are not twisted while they are fitted?

Sign off on the hand chain adjustment