Hoshizaki Modular Flaker F-2000MLH

Ensure only qualified service technicians are servicing the appliance.

Verify that hands are dry before touching the icemaker power switch or control switch.

Move the icemaker's power switch to the 'OFF' position.

Place the disconnect in the off position, if applicable.

Lockout/Tagout to prevent the power supply from being turned back on inadvertently.

Extruding Head Seal Bolts Inspection

Inspect for leakage around seal bolts.

Inspect the upper bearing (extruding head) for wear.

Inspect the lower bearing and O-Ring (lower housing) for wear.

Inspect the mechanical seal for worn, cracked, or scratched contact surfaces.

Inspect the evaporator cylinder for any signs of damage.

Inspect the auger for any signs of wear or damage.

Replace both upper and lower bearings if wear exceeds factory recommendations.

Ensure only qualified service technicians perform the maintenance.

Verify that the icemaker power switch and control switch are not touched with damp hands.

Confirm the icemaker's power switch is in the 'OFF' position and the power supply is turned off.

Ensure Lockout/Tagout procedures are in place to prevent accidental power supply activation.

Check that all components, fasteners, and thumbscrews are securely in place after maintenance.

Cleaning and Sanitizing Instructions

Ensure ammonia type cleaners are not used.

Wear liquid-proof gloves and goggles during cleaning and sanitizing.

Clean or replace water hoses if necessary

Clean the condenser using a brush or vacuum cleaner if necessary

Ensure only qualified service technicians are servicing the appliance.

Verify hands are dry before touching the icemaker power switch or control switch.

Move the icemaker's power switch to the 'OFF' position.

Place the disconnect in the off position, if applicable.

Lockout/Tagout to prevent the power supply from being turned back on inadvertently.

Inspect the air filters for dirt and debris.