EZ Dock Floating Dock 206034PW-**

Clean the EZ Port MAX using a brush, mild cleaning agent, and water

Use a diluted bleach solution for stubborn stains

Use a power washer if convenient

Is there ice pressure in the shoreline area?

Remove or disconnect the dock from moorings if necessary

Remove pipes or piles to prevent bending due to ice pressure

Ensure you have the necessary tools and parts

Adjustment for Long Axel Spoke Roller (250040)

Identify the EZ Port MAX model for long axel spoke roller compatibility

Verify the recommended roller and spacer link positions

Adjust the roller and spacer links as necessary to fit your PWC

Adjustment for Short Axel Spoke Roller (250041)

Identify the EZ Port MAX model for short axel spoke roller compatibility

Verify the recommended roller and spacer link positions

Insert the small bow section into the holes near the front of the entry section

Install bolts for small bow section

Place the full bow section onto the front of the entry section and align it

Install bolts and washers for full bow section

Refer to page 12 for in-line EZ Port MAX applications

Loosen and remove 4 screws (Item 3)

For Position 1: Remove roller (Item 1) and spacers (Item 2), place spacers on top of axle plate, install screws and tighten

For Position 3: Remove roller (Item 1) and spacers (Item 2), place spacers on top of axle plate, install screws and tighten

For Position 4: Remove roller (Item 1), place spacers (Item 2) below plate, install screws and tighten

Align the EZ Port MAX Easy-Lift Entry to an EZ Dock Port MAX Extension

Ensure both parts are level on the water and at the same elevation

Is a counter balance weight needed to offset the installer's weight?

Couple the parts using two EZ Dock Port to Port Coupler Kits

Ensure only flat surfaces are used as walking surfaces