EZ Dock Floating Dock 206033EX-**

Ensure you have the correct model and parts

Adjustment for Long Axel Spoke Roller (250040)

Verify the presence of two spacer links below the roller

Verify the presence of three spacer links above the roller

Is the roller positioned correctly?

Adjustment for Short Axel Spoke Roller (250041)

Verify the presence of one spacer link on each side of the roller

Is the roller positioned correctly?

Keel Roller Adjustment for EZ Port MAX (S25050-BK)

Gather necessary tools: Phillips Screwdriver

Select the desired position for the keel roller

Loosen 4 screws (Item 3) and remove them

Insert the small bow section into the holes near the front of the entry section

Install bolts for small bow section

Place the full bow section onto the front of the entry section and align it

Install bolts and washers for full bow section

Refer to page 12 for in-line EZ Port MAX applications

Clean the EZ Port MAX using a brush, mild cleaning agent, and water

Use a diluted bleach solution for stubborn stains

Use a power washer if convenient

Check if the shoreline area has ice pressure pushes, wind blown ice, or other ice flows

Remove or disconnect the dock from the moorings if necessary

Remove pipes or piles to prevent bending due to ice pressure

Align the EZ Port MAX Easy-Lift Entry to an EZ Dock Port MAX Extension

Ensure both parts are level on the water and at the same elevation

Is a counter balance weight needed to offset the installer's weight?

Couple the parts using two EZ Dock Port to Port Coupler Kits

Ensure only flat surfaces are used as walking surfaces