FreeMotion Indoor Exercise Bike FMEX81912.0

Inspect and tighten all parts of the training bike

Replace any worn parts immediately

Use a damp cloth to clean the bike

Apply a small amount of mild detergent

Record the source of the new pedals

Ensure assembly requires two persons.

Place all parts in a cleared area and remove the packing materials.

Check if any part is preassembled if not found in the hardware kit.

Avoid using power tools to prevent damage.

Ensure the following tools are available (not included)

Attach the Rear Stabilizer (4) to the Base (2) with two M10 x 60mm Bolts (115), two M10 Washers (112), and two M10 Locknuts (116).

Attach the Front Stabilizer (3) to the Base (2) with two M10 x 60mm Bolts (115), two M10 Washers (112), and two M10 Locknuts (116).

Loosen the hex nuts on the saddle clamp a few turns

Retighten the hex nuts on the saddle clamp