Ferno Scoop Stretcher Scoop strecher EXL

Ensure the stretcher is stored in a dry, indoor environment.

Gather necessary cleaning supplies and tools for inspection.

Check that all components are present and in place

Inspect all screws, pins, and levers for correct and firm positioning.

Verify that all mobile parts move normally and correctly.

Inspect for any worn or damaged parts on the stretcher.

Clean the surfaces of the stretcher with a non-abrasive surface disinfectant

Ensure the stretcher is not immersed directly in disinfectant

Check for signs of wear and/or damage during disinfection

Ensure all components of the device are completely dry before reuse

Wear suitable gloves during disinfection

Ensure there are no signs of wear and/or damage on the restraints.

Wear suitable PPE based on the Risk Assessment Document.

Remove the restraints from the device and stretch them to their maximum length.

Remove visible material using a disposable cloth and/or paper and dispose of it in the specific container for special waste.

Immerse the restraints in a container with water and sanitising product, leaving metal and plastic parts outside. Soak for 5-20 minutes.

Was the buckle soaked for more than 5 minutes?

If necessary, wash the buckle with mild soap and water, ensuring it does not soak for more than 5 minutes.

Remove the restraints from the product

Place the restraints inside a mesh bag and put it in the washing machine

Wash the restraints with hot water using a cleaning and disinfecting product and selecting a cycle for delicate items, with slow spin. Do not bleach.

Remove the restraints from the mesh bag and let them dry in the open air. Do not tumble dry.

Re-fit the restraints only once they are dry

Improper maintenance may cause serious accidents and/or damage. Perform maintenance as instructed in this user manual.

When not in use, store the stretcher in an indoor environment that is dry and protected from direct sunlight.

After disinfection/cleaning, ensure that the stretcher and its components are completely dry before use.

Select the lubrication method used

Spray a small amount of lubricant onto the sliding surfaces of the TSLs

Is additional lubrication required for head end and foot end TSLs?

Describe any issues encountered during lubrication