Budgit Portable Electric Hoist 1/2-Ton

d. Inspect Motor, Frame and Electrical Compartment Cover.

(1) Check to see that bolts securing motor to frame are tight.

Also check for any visible damage to motor, such as a cracked end bell or dented stator housing.

(2) Check hoist frame for signs of visible damage.

If frame shows evidence of fracture, the hoist should be disassembled and inspected for further signs of damage from possible overloading.

(1) Operate hoist under load and observe operation of chain over sprocket in both directions of chain travel.

Chain should feed smoothly into and away from the sprocket.

If chain binds, jumps or is noisy, first see that it is clean and properly lubricated.

If trouble persists, inspect chain as outlined below.

(1) Check for bent or distorted hook.

If hook is opened beyond the dimension given in figure 5-5, it must be replaced.

Also check to see that hook swivels and is free to pivot.

Lubricate these points if necessary.

(2) On 2 through 3 ton hoists, check sprockets and bearings in lower block for freedom of movement and signs of damage.

(1) On hook suspended models, check for bent or distorted hook.

If hook is opened beyond the dimension given in figure 5-6, it must be replaced.

Also check to see that hook pivots.

(2) On lug suspended models, check condition of suspension lug.

Replace lug if damaged or cracked.

Coil chain cleaned with oil solvent

Lubricant coated on wear surfaces between links

Sign off on the coil chain lubrication