BINDER Incubator BDS056UL-120V

Ensure compliance with applicable regulations (e.g., DGUV guidelines 213-850 for Germany).

Identify the chamber type and corresponding safety controller class

Safety Controller Function Check

Is the safety controller functioning properly?

Verify the alarm message is displayed when maximum temperature is exceeded.

Temperature Set-point Verification

Enter the current safety controller set-point temperature.

Adjust the safety controller set-point to 2 °C to 5 °C above the desired temperature set-point.

Disconnect the power plug before starting maintenance work

Ensure the chamber does not become wet during maintenance

Verify that maintenance is conducted by licensed electricians or authorized experts

Consult BINDER Service for a maintenance agreement

Is the door gasket cold before replacement?

Replace the door gasket if it is cold

Disconnect the chamber from the power supply

Select cleaning agents for different surfaces

Use the neutral cleaning agent Art. No. 1002-0016 for thorough cleaning

Wipe surfaces with a moistened towel

Remove any residues of the charging material thoroughly

Completely remove cleaning agents from surfaces with a moistened towel

Disconnect the chamber from the power supply by pulling the power plug.

Ensure no decontamination agents that may react with device components are used.

Select the decontamination method based on contamination type and material.

Ensure all inflammable goods are removed before hot air sterilization.

Spray the inner chamber with an appropriate disinfectant.

Ensure the chamber is absolutely dry and ventilated before start-up.