Betenbender Manufacturing Press Brake Machine 6'-70T

Inspect all lines and fittings for leaks

Repair or replace any defective components

Inspect piston rods for leaks or scoring of surface

Replace rod packing if leaks are present

Polish surface thoroughly where scored

Inspect manifold block for leaks

Examine cap screws for looseness

Repair or replace any loose cap screws or nuts

Filter and Strainer Maintenance

Was the return line filter changed during the previous year?

Change return line filter if not done during previous year

Flush clean the suction line strainer

JOG ram down to the bottom of the stroke. Hold switch, read pressure.

Enter the pressure reading in psi

Is the pressure within the maximum limit of 2,500 psi?

Crank limit switches to the lowest position

Put machine in JOG and press DOWN button until cylinders bottom out

Enter the pressure reading in PSI

Turn machine to RUN to re-adjust limit switches

Initial Inspection and Cleaning

Inspect and clean the following parts for dirt and foreign material

Remove rust proofing compound with an acceptable solvent

Use safety glasses and gloves during cleaning

Clean the Press Brake with an approved solvent and clean rags

Ensure no air hose is used for cleaning

Ensure no waste cloth is used for cleaning