Toyota Forklift 7FBCU15

Check loosening at connections at the motor and retighten if loose. Check for any damage on insulation covering

Check battery fluid level and specific gravity

Check loosening at cylinder rod end. Retighten tie rod end set bolt if loose

Check bolts and nuts for tightness. Retighten where required

Grease all greasing points, king pins, rear axle center pin cap, etc

Sign off on the 40 Hourly / Weekly Maintenance

Inspect fork and stopper pin condition

Inspect left and right fork uniformity

Inspect Mast and lift bracket for deformation, damage, and cracks in welded portion

Inspect Mast and lift bracket looseness

Inspect Mast and lift bracket for roller wear, damage, and rotating condition

Inspect Mast strip wear and damage

Inspect Chain and chain wheel for chain tension, deformation, and damage

Inspect Chain anchor bolt condition

Inspect SAS performance of lock cylinder and/or accumulator

Inspect load handing sensor for rust or corrosion

Inspect frame, cross member of the body

Tighten bolts and nuts looseness of the body

Sign off on the safety devices maintenance

Inspect front axle for housing cracks and damage

Inspect rear axle for beam cracks, damage and deformation

Measure axle beam forward and backward direction looseness

Sign off on the equipment system maintenance

Inspect steering Wheel's play and looseness

Inspect steering Wheel's operating condition

Inspect steering valve for oil leakage

Inspect power steering for oil leakage

Inspect mounting and linkage looseness in power steering

Inspect knuckle king pin looseness

Sign off on the steering system maintenance