Schneider Electric Circuit Breaker MTZ1-1600-H2

Condition of Connections and Auxiliaries

Check device mounting in the switchboard

Check the tightness of all main connections

Check the tightness of all auxiliary wiring connections

Auxiliaries and Accessories Installation Check

Check that all auxiliaries and accessories are correctly installed

Connect a PC running Ecoreach software to the mini USB port on the Micrologic X control unit.

Establish a connection and confirm Ecoreach software reads the parameters of the control unit.

Use the Overall System firmware status/compatibility matrix on Ecoreach.

Display the following information

Describe the recommended actions to achieve a compatible system.

Have you followed the recommended actions to get a compatible system?

Connect a PC running Ecoreach software using an RJ45 cable to the communication network

Select devices to be tested from the list of communicating devices in Ecoreach software

Click Run test to test all selected devices

Were the results displayed at the end of the test?

Generate the communication test report with Ecoreach software

Save or print the project report as needed

Use a thin screwdriver to briefly push in (<1 s) the test button on the control unit

Check that the circuit breaker is open

Check that the blue fault-trip reset button has popped out

Check that the Ig/IΔn LED is on

Check that the SDE contacts have switched

Reset the circuit breaker after the test

Record equipment identification

Check that the device is undamaged, correctly mounted, and securely fastened in the switchboard

Check the 3-phase clearance at terminal blocks

Check for debris at the back of the device housing/enclosure

Check that the ground terminals are securely connected with the correct grounding cables

Check that all external surfaces are undamaged

Rectify any non-conformities, if possible

Refer all equipment non-conformities to asset management