Schneider Electric Circuit Breaker MTZ1-1000-H3

Manually charge the mechanism by pulling the spring charging handle down

Check the closing of the device in the different control modes and means designed for the application

Check the opening of the device in the different control modes and means designed for the application

Record equipment identification

Check that the device is undamaged, correctly mounted, and securely fastened in the switchboard

Check the 3-phase clearance at terminal blocks

Check for debris at the back of the device housing/enclosure

Check that the ground terminals are securely connected with the correct grounding cables

Check that all external surfaces are undamaged

Rectify any non-conformities, if possible

Refer all equipment non-conformities to asset management

Connect PC to Micrologic X control unit

Force state of M2C programmable contacts

Force state of digital inputs and outputs

Connect PC running Ecoreach software using RJ45 cable to communication network

Select interface for connection

Check that the control mode is set to Auto: Remote

Ecoreach Software Configuration

Select the circuit breaker in Ecoreach software

Access the Open and Close buttons via the Device tab

Condition of Connections and Auxiliaries

Check device mounting in the switchboard and the tightness of all connections (main connection and auxiliary wiring)

Check that all auxiliaries and accessories are correctly installed