Pitco Gas Fryer SSH55

Check that the high temperature limit and temperature probe are in the correct position and secured in place

Check that wires and cords are not frayed or loose in and out of the cabinet

Check around the appliance for loose parts or accessories that need to be secured or other foreign items (e.g., Aerosol cans) that should be removed from the area

Check for oil/shortening leaks around the in and out of the cabinet and around the appliance

Wear apron, heat resistant gloves, and goggles for protection

Read the operation section of the manual prior to filling or operating the appliance

Do not leave the appliance unattended during cleaning

Electrical Connections and Harnesses

Check electrical connections and harnesses for integrity

Check temperature probes and limits for carbon build up and plating

Clean temperature probes and limits if required

Check proper mounting of probes and sensors

Ensure all fasteners are secure

Unscrew filter strainer cap from pickup tube and gently tap to dislodge crumbs

Use a clean cloth to remove remaining crumbs and reattach strainer cap

Filter Pickup Assembly Cleaning

Scrape loose debris and crumbs from filter pickup assembly and filter pan with filter scoop shovel

Remove filter pickup and place in pot sink, power soak sink or dishwasher for cleaning

Ensure all surfaces are rinsed thoroughly and dried before re-assembly

Wipe filter pan with clean damp cloth and food grade detergent

Electrical and Power Connections

Check electrical connections and harnesses.

Check IEC power cords are fully engaged and secure.

Check for any air or shortening leaks and for excessive oil build-up.

Check O-Ring on filter pickup tube and replace as needed.

Check filter strainer on pickup tube.

Ensure the thermometer is suitable for temperatures up to 380°F (182°C)

Place the thermometer in the oil above the tip of the fryer’s temperature probe within 1” (2.54 cm / 25.4 mm)

Ensure the thermometer does not touch the heat tube

Record the temperature reading from the thermometer

Record the controller’s setpoint temperature

Is the thermometer reading within ± 5°F (± 3°C) of the controller’s setpoint?