Pitco Gas Fryer SG18WKS

Fill the tank with water and add one packet of Pitco fryer cleaner or mild detergent

Turn gas valve knob to ON position

Press the power switch on the front panel to the ON position

Did the fryer water begin boiling?

Turn unit off and let soak for ten minutes

Ensure all necessary equipment is available

Refer to KFC Standards Library for shortening disposal

Rotate the drain down spout into the container

Open the blue handled drain valve

Is the container full or the fry tank empty?

Close the blue handled drain valve

Repeat draining process if container was full

Disconnect the power supply before cleaning

Clean the fryer according to KFC Standards Library instructions

Ensure fryer is cleaned to maintain peak performance and appearance

Ensure shortening is filtered and filter media is replaced before starting the polishing procedure.

Remove filter pan assembly from fryer and clean according to KFC Standards Library instructions.

Replace filter media and add filter aid to crackling basket tray.

Put oil flow selector valve into polish position by pulling red selector valve handle out.

Open drain valve by pulling blue drain valve handle down.

Push power switch to the PUMP position and start polish timer.

Ensure filter media is replaced before performing polishing procedure

Ensure the filter module is stored neatly under the fryer

Wear insulated oil-proof gloves

Has the filter assembly cooled to room temperature?

Ensure the filter pan is empty of shortening

Remove the filter pan by grasping the handle and pulling toward the front of the fryer

Filter Screen Pickup Assembly Cleaning