Nordson Horizontal Band Saw H-20

Warning: This maintenance check requires trained personnel with PPE!

Enter the machine's hour meter reading

Is the oil filter in good condition?

Select the replacement oil filter used

Sign off on the oil filter maintenance

NOTE: Wear gloves, safety glasses and a long sleeve shirt for protection from the sharp blade. The hydraulics should be OFF any time the operator has his/her hands in contact with the blade.

Select MANUAL mode and raise the head so the drive door will clear the electrical control panel.

Release the blade tension by turning the Blade Tension Switch to '-'.

Shut the machine off and open the idler and drive doors.

Loosen the carbide locking levers by turning counter clockwise 1/4 turn.

At the top of the head, the saw blade runs in a protective channel. Grip the blade at each end of this channel and twist the blade teeth down past the channel and slide the blade forward. Let the blade rest on the out feed table, then slide the blade down and out of the carbide guides.

Before installing the new blade, check that it measures 1.615' wide including the teeth.

Your new blade will be in a coil. While wearing gloves, hold the blade away from yourself, twist the blade to uncoil it. Do not let the blade teeth bounce on the concrete floor as some damage to the blade may be caused.

Release blade tension before adjusting. Adjust tracking by regulating "push" set screws and "pull" bolts. Loosening bolts "A" and turning in setscrews "C" by equal amounts will move the blade OFF the wheel. Loosening bolts "B" and turning in sets crews "D" by equal amounts will move the blade ON to the wheel.

After each "C" or "D" set screw adjustment, tighten bolts "A" or "B", turn tension switch to "+RUN", run the blade for a moment and recheck the tracking.

Release blade tension before adjusting. Loosening bolts "A" and turning in set screws "C" by equal amounts will move the blade OFF the wheel. Loosening bolts "B" and turning in set screws "D" by equal amounts will move the blade ON to the wheel.

After each "C" or "D" set screw adjustment, tighten bolts "A" or "B", turn tension switch to "+ RUN", run the blade for a moment and recheck the tracking.;

Warning: Ensure the machine is turned off and unplugged before starting the procedure.

Are the set screws in the handle bases loosened?

Are the large hubs with a flat on each side and a socket head cap screw inside the center visible?

Are the screws holding the carbide pads in place?

Are the hubs used to adjust the position of the carbide pads by turning clockwise to tighten the pads on the blade?

Are the hubs tightened against the blade, backed off 1/16 to 1/8 of a turn?

Is the handle installed in the LOCKED position and the set screws tightened?

Are the handles swung to the unlocked position and back to the locked position?

Warning: This maintenance check requires trained personnel with PPE!

Enter the machine's working hours

If machine's working hours are less than 50, stop the procedure

Choose the replacement element used

Oil filter replaced successfully?

Sign off on the oil filter maintenance