Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Mitsubishi Split-Type, Heat Pump Air Conditioner PUMY-SP140YKM.TH-BS
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
Fan Motor Disassembling
Remove the service panel
Upload a photo of the service panel removed
Remove the top panel
Upload a photo of the top panel removed
Remove 4 fan grille fixing screws (5 × 12) to detach the fan grille
Upload a photo of the fan grille detached
Remove a nut (for right handed screw of M6) to detach the propeller
Upload a photo of the propeller detached
Disconnect the connector CNF1 on the multi controller circuit board in the electrical parts box
High Pressure Switch Disassembling
Upload a photo of the service panel before removal
Service panel removed
Upload a photo of the top panel before removal
Top panel removed
Refer to procedure 3 for removing the electrical parts box
Electrical parts box removed
Refer to the procedure 7 (3) for removing the side panel (R)
Side panel (R) removed
2 lead wire of the high pressure switch pulled out
Outdoor Unit Refrigirant Charging
Cautions for service
Refrigerant recovered from the unit completely
Refrigerant not released in the air
Cycle charged with specified amount of refrigerant after service
Filter drier installed during service
Filter drier used for new refrigerant
Additional refrigerant charge
Cylinder for R410A is a syphon type
Charging performed with the cylinder of syphon stood vertically
TH2 and TH4 Thermistors Disassembling
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3) Disconnect the following connectors on the controller circuit board in the electrical parts box.
•TH2: Black
•TH4:White
[Removing the thermistor <HIC> (TH2)]
(4) Loosen the fastener fixing the connector to the electrical parts box. (See Photo 10)
(5) Pull out the thermistor <HIC> (TH2) from the sensor holder. (See Photo 13)
[Removing the thermistor <Compressor> (TH4)]
Electrical Parts Box Disassembling
Disconnect all the connectors on the multi controller circuit board
Remove 2 screws 1 which fix the plate holding the multi controller circuit board and the electrical parts box
Remove the multi controller circuit board
Disconnect the M-NET power board connector on the back plate of the controller circuit board
Disconnect all the connectors on the noise filter circuit board
Remove 9 supports on the noise filter circuit board
Remove the noise filter circuit board
Remove the noise filter plate fixing screws
Disconnect the connectors of reactor on the bottom plate of the electrical parts box
Access the parts list for your equipment in MaintainX.
Joint
CMY-Y62-G-E
Header
CMY-Y64/68-G-E
Joint
CMY-Y62-G-E
Header
CMY-Y64/68-G-E
Joint
CMY-Y62-G-E
Header
CMY-Y64/68-G-E
MaintainX CoPilot is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX













