Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Mitsubishi Split-Type, Heat Pump Air Conditioner PUMY-SP140VKMR1.TH
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
TH2 and TH4 Thermistors Disassembling
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3) Disconnect the following connectors on the controller circuit board in the electrical parts box.
•TH2: Black
•TH4:White
[Removing the thermistor <HIC> (TH2)]
(4) Loosen the fastener fixing the connector to the electrical parts box. (See Photo 10)
(5) Pull out the thermistor <HIC> (TH2) from the sensor holder. (See Photo 13)
[Removing the thermistor <Compressor> (TH4)]
Electrical Parts Box Replacement
Upload a photo of the service panel before removal
Service panel removed successfully
Upload a photo of the top panel before removal
Top panel removed successfully
Upload a photo of the disconnected connecting wire from terminal block
Connecting wire from terminal block disconnected successfully
Upload a photo of the disconnected connector CNF1, 4-way valve coil, LEV-A and LEV-B on the multi controller circuit board
Connector CNF1, 4-way valve coil, LEV-A and LEV-B on the multi controller circuit board disconnected successfully
Upload a photo of the disconnected pipe-side connections of the following parts: Thermistor <HIC> (TH2), Thermistor <Compressor> (TH4), Thermistor <Liquid> (TH3), Thermistor <Suction> (TH6), Thermistor <Ambient> (TH7)
Solenoid Valve Coil and Solenoid Valve Disassembling
Upload Photo 1
Service panel removed
Top panel removed
Connector SV1 (Gray) on the multi controller circuit board disconnected
Electrical parts box removed
Solenoid valve coil fixing screw (M4 ×6) removed
Solenoid valve coil removed by sliding the coil upward
Refrigerant recovered
Welded part of solenoid valve removed
4-Way Valve Disassembling
Remove the service panel
Upload a photo of the removed service panel
Remove the top panel
Upload a photo of the removed top panel
Remove the electrical parts box
Remove 3 valve bed fixing screws (5 × 12) and 4 stop valve fixing screws (5 × 16) and then remove the valve bed
Upload a photo of the removed valve bed
Remove 4 right side panel fixing screw (5 × 12) in the rear of the unit and then remove the right side panel
Remove the 4-way valve coil
LEV Disassembling
Upload a photo of the service panel before removal
Service panel removed
Upload a photo of the top panel before removal
Top panel removed
Refer to procedure 3 for removing the electrical parts box
Electrical parts box removed
Refer to procedure 8 for removing the LEV coil
LEV coil removed
Refrigerant recovered without spreading it in the air
Access the parts list for your equipment in MaintainX.
Joint
CMY-Y62-G-E
Header
CMY-Y64/68-G-E
Joint
CMY-Y62-G-E
Header
CMY-Y64/68-G-E
Joint
CMY-Y62-G-E
Header
CMY-Y64/68-G-E
MaintainX CoPilot is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX













