Mitsubishi Air Conditioner PLA-RP125BA2

Remove the air intake grille and the filter

Remove the 2 screws from the electrical box cover

Remove the 6 supports from indoor controller board

Remove the indoor controller board

Remove the air intake grille and the filter

Remove the 2 screws from the electrical box cover

Remove the electrical wiring service panel (3 screws)

Remove the 4 screws and pull out the drain pan

Pull out the left and right of the pan gradually. Be careful not to crack or damage the pan.

Upload a photo of the removed drain pan

Upload a photo of the removed turbo fan

Upload a photo of the removed wiring clamps

Remove the coil plate (2 screws)

Remove the thermistors which are inserted into the holders installed to the thin copper pipe

Disconnect the 4-pin white connector (CN44)

Remove the air intake grille and the filter

Remove the 2 screws from the reactor cover

Disconnect the relay connector of reactor

Remove 2 reactor fixing screws and remove the reactor

Warning: Ensure the machine is powered off before starting the procedure

Air intake grille and filter removed

Connector CNV (White/20P) disconnected

2 screws from the panel removed

Sign off on the panel disassemble