Mitsubishi Air Conditioner PLA-RP50BA

Slide the knob of air intake grille toward the arrow 1 to open the air intake grille.

Remove drop prevention hook from the panel.

Slide the shaft in the hinge to the direction of the arrow 2 and remove the air intake grille.

Sign off on the disassembly of the air intake grille.

Refrigerant recovered from the unit completely

Refrigerant not released in the air

Cycle charged with specified amount of refrigerant after service

Filter drier installed for service

Filter drier used for new refrigerant

Cylinder for R410A is a syphon type

Charging performed with the cylinder of syphon stood vertically

Upload a photo of the removed electrical box

Remove the bell mouth (3 screws)

Upload a photo of the removed bell mouth

Remove the wire cover (3 screws)

Disconnect the connector of the fan motor (CNMF)

Upload a photo of the removed drain pan

Cut the hose band and remove the hose

Upload a photo of the removed hose

Remove the drain pump assembly (3 screws and 2 hooks)

Upload a photo of the removed drain pump assembly

Remove the drain pump (3 screws)

Upload a photo of the removed drain pump

Remove the float switch (2 screws)

Remove the air intake grille and the filter

Remove the 2 screws from the electrical box cover

Remove 2 electrical box fixing screws and remove 2 hooks

Electrical parts in the electrical box

Check all the parts found in the electrical box

Sign off on the electrical box disassemble