Mitsubishi Air Conditioner PLA-RP125BA

Remove the air intake grille and the filter

Disconnect the connector CNV (White/20P)

Slide the corner panel to the direction of the arrow 1, and remove the corner panel

Remove the 2 screws from the panel which fix to the oval holes

Rotate the panel a little to come to the bell shaped hole where the screw is large and remove the panel

Remove the air intake grille and the filter

Remove the 2 screws from the electrical box

Disconnect the connector CN20 (Red) from the indoor controller board

Remove the room temperature thermistor and holder

Upload a photo of the removed drain pan

Upload a photo of the removed turbo fan

Upload a photo of the removed wiring clamps

Remove the coil plate (2 screws)

Remove the thermistors which are inserted into the holders installed to the thin copper pipe

Disconnect the 4-pin white connector (CN44)

Upload a photo of the removed drain pan

Cut the hose band and remove the hose

Remove the drain pump assembly (3 screws and 2 hooks)

Remove the drain pump (3 screws)

Remove the float switch (2 screws)

Sign off on the disassembly process

Remove the air intake grille and the filter

Remove the 2 screws from the electrical box cover

Remove the 6 supports from indoor controller board

Remove the indoor controller board