Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Kubota Front Loader LA765

Create an account to install this asset package.

Maintenance Plans for Kubota Front Loader Model LA765

Integrate maintenance plans directly into your work orders in MaintainX.

10 Hourly Front Loader Maintenance

!CAUTION

• For check and repair, park the tractor on flat ground and apply the parking brake.

• For check and repair, lower the bucket and stop the engine.

• Remove the key.

Lubrication

1. Lubricate all grease fittings every 10 hours of operation.; Also, lubricate joints of control lever linkage every 10 hours.; High quality grease "extreme pressure" and containing molybdenum disulfide is recommended.; This grease may specify "Moly EP" on its label.

2. Daily before operation, check the tractor hydraulic fluid level.; If low, add as in the previous page.; Also change the filter element and the hydraulic fluid as recommended in the tractor's operator's manual.;

Run this procedure

20 Hourly Front Loader Maintenance

CAUTION: For check and repair, park the tractor on flat ground and apply the parking brake.

For check and repair, lower the bucket and stop the engine.

Remove the key.

Re-tightening of Hardware

After 20 to 30 hours of initial loader operation, re-tighten all mounting bolts and nuts to the required torque value as follows.

Main frame bolts (M16) - 226 N·m/23.0 kgf·m/166 lbf·ft

Sign off on the maintenance procedure

Run this procedure

50 Hourly Front Loader Maintenance

CAUTION: Park the tractor on flat ground and apply the parking brake for check and repair.

Lower the bucket and stop the engine for check and repair.

Remove the key before starting the maintenance.

CAUTION: Never operate front loader with a loose main frame.

Any time bolts are loosened, retighten to specified torque.

Check all bolts frequently and keep them tight.

Check main frame bolts and nuts regularly especially when new.

Enter the torque of the main frame mounting bolt in N·m

CAUTION: Never operate front loader with a loose main frame.

Run this procedure

1 Daily Front Loader Maintenance

!CAUTION

• For check and repair, park the tractor on flat ground and apply the parking brake.

• For check and repair, lower the bucket and stop the engine.

• Remove the key.

Checking Transmission Fluid Level

1. Park the machine on a flat surface, lower the implement and stop the engine.

2. To check the oil level, pull out the dipstick, clean it, replace it, and pull it out again.; Check to see that the oil level is between the two notches.

If the level is too low, add new oil to the prescribed level at the oil inlet.; (Refer to "3. LUBRICANTS" on page G-3)

IMPORTANT

Run this procedure