Inoxpa Valve VA47-1-77-04-61-100

Ensure the actuator is without pressure before starting assembly or disassembly

Open the cover of the control head

Unscrew the magnet of the actuator shaft (08A)

Unscrew the two M5x10 screws that fix the control head to the actuator

Unscrew the core (55) with the help of a 19 mm wrench

Unscrew the shaft (08A) from the actuator with the help of a 10 mm wrench

Place the manual connecting rod (04) and the lever assembly connecting rod (04A) on the discs shafts (03,03A) and fix them with screws (23D,23E)

Place the nuts (26) and tighten them

Place the discs (03,03A) in the open position.

Place the actuator connecting rod (04C) on the disc shaft (03A) as shown in the figure 10.011.32.0018.

Place the connecting rod (04D) on the disc shaft (03) as shown in the figure 10.011.32.0018 and fix it with the screw (23H).

Place the bushings, washers, and drive arm

Place the nuts (26) and tighten them.

Actuator and Support Installation

Supply compressed air to the actuator.

Place the support (21) and the actuator (10) on the actuator connecting rod (04C) and place the pin (50) which joins the connecting rod (04C) to the actuator (10).

Proceed with caution to avoid personal injury.

Disconnect the compressed air before starting to disassemble the valve.

Read instructions carefully before disassembling the valve clamps.

Ensure only qualified persons perform valve and actuator assembly and disassembly.

Gather the necessary tools for disassembly and assembly

Lubricate the discs (03,03A) and the seat seals (05) with the specified grease.

Check for absence of leaks around the valve

Ensure smooth operation of the valve

Record details of the valve maintenance

Enter the valve operation statistics

Use statistics to plan next inspection