Inoxpa Valve VA47-1-10-04-78-025

Check for any visible leaks around the valve

Ensure the valve operates smoothly without any resistance

Does the valve operate smoothly?

Record any maintenance performed on the valve

Verify seal material compatibility

Check the concentration of the cleaning solutions

Perform final rinse with clean water

Place the O-ring (20A) on the leak detector shaft (08)

Place the O-ring (20D) on the leak detector drive bushing (17C)

Place the O-rings (20C,20D) on the leak detector body (01A)

Assembly of Leak Detector Components

Pass the leak detector shaft (08) with its O-rings through the bottom part of the leak detector body (01A)

Place the spring (06) on the leak detector body (01A)

Place the leak detector drive bushing (17C) and pass the pin through its hole to fix the shaft

Ensure the actuator is without pressure before starting

Release the compressed air supply

Remove the adapter and the air connection on the top part of the actuator

Screw the shaft (08A) on the top part of the piston with a 10 mm wrench

Insert the adapter (13) supplied with the kit through the shaft (08A)

Place the seals (20B,20C,20D) on the core (55)

Insert the core (55) in the adapter (13) and screw it on the actuator with a 19 mm wrench

Screw the air fitting (18) on the adapter (13)

Remove the plugs from the manual connecting rod and the assembly handle connecting rod

Loosen the screws and remove the connecting rods with the handle assembly

Remove the drive arm, the bushings, and the washers

Remove the plugs from the valve half-bodies