Inoxpa Valve VA47-1-00-06-52-063

Loosen the screws (23D,23E) and remove the connecting rods (04,04A) with the handle assembly

Loosen and remove the nuts (26)

Remove the drive arm (04B), the bushings (17C) and the washers (25)

Ensure the actuator is without pressure before starting assembly or disassembly

Open the cover of the control head

Unscrew the magnet of the actuator shaft (08A)

Unscrew the two M5x10 screws that fix the control head to the actuator

Unscrew the core (55) with a 19 mm wrench

Unscrew the shaft (08A) from the actuator with a 10 mm wrench

Place the discs (03,03A) in the open position.

Connecting Rod and Disc Shaft Assembly

Place the actuator connecting rod (04C) on the disc shaft (03A) as shown in the figure 10.011.32.0018.

Place the connecting rod (04D) on the disc shaft (03) as shown in the figure 10.011.32.0018 and fix it with the screw (23H).

Bushing and Drive Arm Installation

Place the bushings (17C), the washers (25) and the drive arm (04B).

Place the nuts (26) and tighten them.

Actuator and Support Installation

Proceed with caution to avoid personal injury.

Disconnect the compressed air before starting to disassemble the valve.

Read instructions carefully before disassembling the valve clamps.

Ensure only qualified persons perform valve and actuator assembly and disassembly.

Gather the necessary tools for disassembly and assembly

Lubricate the discs (03,03A) and the seat seals (05) with the specified grease.

Proceed with caution to avoid personal injury.

Disconnect the compressed air before starting to disassemble the valve.

Read instructions carefully before disassembling the valve clamps.

Ensure only qualified persons perform valve and actuator assembly and disassembly.

Gather the necessary tools for disassembly and assembly

Loosen the screws (23) joining the flanges (02A) to the half-bodies (02).