Ingersoll Rand Air Compressor XF300

Safety Instructions: Read before starting any maintenance

Tools: Use correct tools for the procedure

Spares: Have recommended spares on hand

Old element loosened with suitable device

Sealing surface of the filter wiped with clean, lint-free rag

Replacement element removed from its protective package

Small amount of clean lubricant applied on the rubber seal of the replacement element

Replacement element installed correctly

Before starting any maintenance, be certain the following is heeded.

Have recommended spares on hand.

Inspect Discharge temperature (air)

Inspect Separator element differential

Inspect Air filter Delta P (at full load)

Before starting any maintenance, be certain the following is heeded.

Have recommended spares on hand.

Replace Premium Coolant* (ULTRA)

In very clean operating environments and where inlet filter is changed at the above prescribed intervals.

In extremely dirty environments change coolant, filters, and separator elements more frequently.

Sign off on the coolant replacement

Have recommended spares on hand

Is '?' flashing on the screen and the display says 'CHANGE INLET FILTER'?

Loosen wing nut on top of inlet filter housing

Lift cover up and away to expose element/s

Safety Instructions: Always relieve pressure before removing caps, plugs, covers or other parts. Blow down pressurized air system. Close isolation valve.

Use correct tools and have recommended spares on hand.

Have recommended spares on hand

Separator differential pressure ( Δ P)

Replace separator element when the separator differential pressure ( Δ P) reaches three times the initial pressure drop or a maximum pressure differential of 12 psi (.8 bar) at full load or if the Intellisys warning CHANGE SEPARATOR ELEMENT is displayed.

Run compressor in full load mode and at rated pressure and observe “Separator Pressure Drop” on the CURRENT STATUS display screen.

If the display says “xxPSI”, then no maintenance is required. If “ ? ” is flashing on the screen and the display says “CHANGE SEPR ELEMENT”, then the separator element should be replaced.