Ingersoll Rand Air Compressor EPE300

Have recommended spares on hand

Relubrication Interval - 60 Hz (or 9 months, whichever comes first)

1000 hours all TEFC drive motors

2000 hours all ODP drive motors and all fan motors

Before starting any maintenance, be certain the following is heeded.

Have recommended spares on hand

Sign off on the hoses inspection

Before starting any maintenance, be certain the following is heeded.

3) Have recommended spares on hand.

To check condition of the inlet filter, run compressor in the LOADED mode and observe “Inlet Filter” on the CURRENT no maintenance is required. If “ ? ” is flashing on the screen and the display says “CHANGE INLET FILTER”, then the inlet filter should be changed.

To change inlet filter elements, loosen wing nut on top of inlet filter housing. Lift cover up and away to expose element/s.

Carefully remove the old element/s to prevent dirt from entering the inlet valve. Discard old element/s.

Thoroughly clean the element housing and wipe all surfaces.

Install new element/s and inspect to ensure that they have seated properly.

Before starting any maintenance, be certain the following is heeded.

Have recommended spares on hand

Extended life Premium coolant* (ULTRA EL)

In very clean operating environments and where inlet filter is changed at the above prescribed intervals.

In extremely dirty environments change coolant, filters, and separator elements more frequently.

Have recommended spares on hand

Loosen the old element using a suitable device

Use drain pan to catch any leakage during removal

Wipe the sealing surface of the filter with a clean, lint-free rag

Remove the replacement element from its protective package

Apply a small amount of clean lubricant on the rubber seal and install the element