Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Ingersoll Rand Air Compressor XF350

Create an account to install this asset package.

Maintenance Plans for Ingersoll Rand Air Compressor Model XF350

Integrate maintenance plans directly into your work orders in MaintainX.

4000 Hourly/6 Monthly Cooler Cores Cleaning

Safety Instructions

Read Safety Instructions

Use correct tools

Have recommended spares on hand

COOLER CORES: CLEANING

Ensure the compressor is isolated from the compressed air system by closing the isolation valve and venting pressure from the drip leg.

Ensure the main power disconnect switch is locked open and tagged.

TOOLS REQUIRED

Select the tools used

Run this procedure

16000 Hourly/3 Yearly Extended Life Premium Coolant Replacement

Before starting any maintenance, be certain the following is heeded.

Read Safety Instructions

Use correct tools

Have recommended spares on hand

Extended life Premium coolant* (ULTRA EL)

Enter the current operating hours of the machine

Is the operating environment very clean?

Is the inlet filter changed at the prescribed intervals?

Is the operating environment extremely dirty?

Run this procedure

2000 Hourly/1 Yearly Coolant and Vibration Monitoring

Before starting any maintenance, be certain the following is heeded.

1) Read Safety Instructions.

2) Use correct tools.

3) Have recommended spares on hand.

FLUID AND VIBRATION MONITORING

Ingersoll Rand recommends incorporating predictive maintenance, specifically the use of coolant and vibration analysis, into all Preventative Maintenance programs.

Predictive Maintenance is designed to increase system reliability and prevent costly downtime.

Through the use of sophisticated diagnostic tools, including fluid, vibration, and optional air analysis, IRA Certified Service Technicians can identify and correct potential problems BEFORE they can cause expensive unscheduled downtime.

How does predictive analysis work? By establishing an initial baseline for normal operation, and then regularly monitoring fluid and vibration conditions, any sudden deviation or significant increase from this baseline can be identified and investigated to pinpoint the cause.

Run this procedure

4000 Hourly/1 Yearly Separator Tank Scavenger Screen/Orifice Cleaning

Before starting any maintenance, be certain the following is heeded.

Read Safety Instructions

Use correct tools

Have recommended spares on hand

TOOLS REQUIRED

Select the tools used

PROCEDURE

The screen/orifice assemblies are similar in appearance to a straight tubing connector and will be located between two pieces of 1/4 inch O.D. scavenge line tubing.

The main body is made from 1/2 inch hexagon shaped steel and the diameter of the orifice and a direction-offlow arrow is stamped in flat areas of the hexagon.

Run this procedure

2000 Hourly Coolant Filter Replacement

Safety Instructions: Read before starting any maintenance

Use correct tools and have recommended spares on hand

Suitable device used to loosen the old element

Drain pan used to catch any leakage during removal

Old element discarded

Sealing surface of the filter wiped with a clean, lint-free rag

Replacement element removed from its protective package

Small amount of clean lubricant applied on the rubber seal of the replacement element

Replacement element installed

Run this procedure