Hyster Forklift J30NXT

Warning: Always apply the parking brake when leaving the seat.

Service brakes operate correctly

Automatic Parking Brake (APB) indicator icon illuminated

Alarm sounds when APB is not applied and operator leaves the seat or turns the key or keyless switch to OFF position

APB holds a lift truck with a capacity load on a 15% grade

If parking brake requires adjustment, describe the issue

Sign off on the Automatic Parking Brake check

Indicator Light functional during operation

Parking Brake applies and releases properly

Parking Brake holds full capacity load on a 15% grade

WARNING: Never put tools or other metal on the battery. Metal on the battery can cause a short circuit and possible damage or injury.

The acid in the electrolyte can cause injury. If the electrolyte is spilled, use water to flush the area. Make the acid neutral with a solution of sodium bicarbonate (soda). Acid in the eyes must be flushed with water immediately.

Batteries generate explosive fumes. Keep the vents in the caps clean. Keep sparks or open flames away from the battery area. DO NOT make a spark from the battery connections.

Disconnect the battery when doing maintenance.

Voltage and weight of the battery are correct as shown on the Nameplate

Battery case and the area for the battery clean and painted

Battery and the battery area cleaned with a water and sodium bicarbonate (soda) solution

Top of the battery clean, dry and free of corrosion

Battery held within the compartment in case of tipover

Front and rear bulkheads in place

Left and right frame plates in place

Lift truck equipped with optional side rollers on the battery plate

Hood and hood latch mechanism functional

Hood can be raised for access to the battery

Warning: Forks must be removed or installed by trained personnel only.

Warning: DO NOT try to move a fork without a lifting device. The forks can weigh 45 to 115 kg (99 to 254 lb).

Note: Forks are to be replaced only in sets and not individually.

Check condition of forks. Replace if necessary.

Lower the carriage and remove four capscrews from inner fork carriers. Remove inner fork carriers from fork positioner.

Slide a hook fork to the fork removal notch on the carriage. Lower the fork onto blocks so that the lower fork hook moves through the fork removal notch.

Lower the carriage further so that the top fork hook is disengaged from the top carriage bar. Move the carriage away from the fork, or use a lifting device to move the fork away from the carriage.