Goulds Pumps Vertical Turbine Pump VIT-FF 11A

5.8 Lubricate the thrust pot during a shutdown period

Completely immerse the bearings in oil

Fill the oil reservoir until the oil runs over the oil retainer tube and down the shaft

Before startup, drain the oil to its required level

Thrust pot lubrication guidelines

Verify lubrication requirements

Measure oil level when not operating

Is the oil level within the required range when not operating?

Is the oil level lower than the required level when operating?

Ensure pump is not operated if oil level is not at the required level

4.4.11 Set up the lubrication system

Observe instructions on the submittal document.

Fill the oil reservoir with oil.

Check the lubricator feed and ensure the oil reservoir is flowing freely.

Set the proper drops per minute on the regulator based on shaft size.

Use synthetic turbine oil ISO VG 32 for general applications.

Consult ITT for more specific data if necessary.

Check for unusual noise, vibration, and bearing temperatures of thrust pot or electric motor

Ensure bearing housings are free from insulation and dust accumulation

Check the pump and piping for leaks

Ensure safety precautions are followed

6.4.2 Disassemble the head and column

Remove necessary components based on drive type

Uncouple the driver or gear box from the pump shaft and mounting flanges

Remove all hold-down bolts and integral piping

Remove the coupling and mechanical seal

Continue disassembly down to the bowls