Goulds Pumps Vertical Turbine Pump VIT-FF 6J

Allow time for seal adjustment if slight leaks occur at start-up

Run pump continuously if leaks decrease while running

Check for constant leaks during operation

Inspect for secondary seal damage or warped/cracked seal faces if constant leaks occur

Replacement guidelines — Mechanical seal checks

Check shaft or sleeve for pits, burrs, or sharp edges

Polish shaft or sleeve with fine emery cloth to remove burrs and sharp edges

Check that the foundation and the hold-down bolts are tight

4.4.11 Set up the lubrication system

Observe instructions on the submittal document

Fill the oil reservoir with oil

Check the lubricator feed and ensure the oil reservoir is flowing freely

Set the proper drops per minute on the regulator

Is synthetic turbine oil ISO VG 32 used for general applications?

Consult ITT for more specific data if needed

2.4 Pump and bowl assembly storage requirements

Rotate the shaft and bowl assembly shaft counterclockwise at least 3 turns

Ensure the shaft is not left in a previous or extreme position

Check that the shaft rotates freely

2.4 Pump and bowl assembly storage requirements

Inspect the unit to ensure all preservatives are intact

Seal all pipe threads and flanged pipe covers with tape

Renew rust preventative on all uncoated surfaces

2.4.1 Extended long-term storage for partially assembled pumps

Check for unusual noise, vibration, and bearing temperatures of thrust pot or electric motor

Ensure bearing housings are free from insulation and dust accumulation

Check the pump and piping for leaks