Davis Packaging Dual Roll Console TD - 362

Turn on unit and allow to heat until film cuts easily.

Pull and tear off wrapping film

Wad film into small baseball sized ball.

Gently rub film ball back and forth across Cutting Rod to remove any film residue.

Turn off or unplug unit and let cool for approximately 4 minutes.

Blow or brush film debris from unit after rod and seal plate have fully cooled.

Deep Cleaning Cutting Rod of Burnt Film

TURN OFF, UNPLUG THE UNIT, AND LET THE MACHINE COOL DOWN BEFORE CLEANING.

Unplug the unit and let it cool down before proceeding

Use caution to not overtighten screws or strip screw threads when removing/reinstalling screws

Slide the heat tray drawer out after unplugging and letting the unit cool

Remove the underside heat drawer cover by removing 10 small Phillips screws around the bottom cover

Take a picture of the wiring as a reference for reinstalling

Follow the metal thermostat coil wire to the center of the heat plate and remove the thermostat bulb by removing the 3 Phillips screw clips

Ensure power is unplugged before beginning

Unscrew 4 screws on front of unit to release power box

Unscrew power box cover and document wire positions

Take picture or note position of colored wires

Squeeze plastic pins and slowly rock circuit board out of box

Reconnect wires to new circuit board

Unplug the unit and let it cool down before proceeding

Use caution to not overtighten screws or strip screw threads when removing/reinstalling screws

Slide the heat tray drawer out after cooling

Remove the underside heat drawer cover by removing small Phillips screws around the bottom cover

Take a picture of the wiring as a reference for reinstalling

Remove screws from first retainer plate and remove element

Let the machine cool down before cleaning

Non-Stick Cover Inspection and Cleaning

Inspect the Non-stick cover for the following issues

Is the Non-stick cover in good condition?

Clean the Non-stick cover if it is not overly soiled or damaged