Daikin Indoor Unit Cooling Only Air Conditioner FTKD25GVMV

Warning: Be sure to wait for 10 minutes or more after turning off all power supplies before disassembling work.

Indoor heat exchanger thermistor released

INTELLIGENT EYE sensor PCB removed

Warning: Be sure to wait for 10 minutes or more after turning off all power supplies before disassembling work.

Remove the screw covers and screws. (right and left)

Open the horizontal blades before removing the screw covers and screws.

When reassembling the indoor unit, drive the screws with the horizontal blades opened or removed.

Unfasten the 3 hooks on the top of the front grille.

The convex marks (...) on the front panel indicate the position of the hooks.

Pull the upper part of the front grille out and lift the lower part up, and then remove the front grille.

When reassembling, make sure that the 3 hooks are fastened as they were.

When reassembling the front grille, be sure not to get it stuck on the spacer of the drain pan.

Warning: Be sure to wait for 10 minutes or more after turning off all power supplies before disassembling work.

Open the front panel over the position where it stops.

Slide the left rotary shaft to the right and release it.

Remove the right rotary shaft in the same way.

When reassembling the front panel, fit the right and left rotary shafts one by one into the grooves and fully push them into position.

Sign off on the front panel removal

Warning: Be sure to wait for 10 minutes or more after turning off all power supplies before disassembling work.

The air filter is not marked for difference between the right and left sides.

Insert the air filter with the “FRONT” mark faced up.

The air filter can be set easily by inserting it along the guides.

Be sure to insert the hooks (at 2 lower positions) when mounting the air filter.

2) Pull out the air filter downward and remove it.

2. Remove the Titanium apatite photocatalytic airpurifying filters.

Warning: Be sure to wait for 10 minutes or more after turning off all power supplies before disassembling work.

Inserting a wooden base beneath the unit facilitates the removing work.

Lift up the indoor unit slightly and pull out the drain hose.

Place a plastic sheet under the drain pan to prevent from wetting the floor with remaining drain.

1) Remove the screw at the right side of the drain pan unit.

2) Press the right side of the drain pan unit and twist the left side.

3) Remove the drain pan unit from the indoor unit.

When reassembling, make sure that the hook at the left side is fitted in the groove.