C.S.F. Inox Centrifugal Pump CS 32-110

Ensure the pump is turned off and isolated from the power supply

Gather necessary tools and replacement bearings

Remove the pump casing to access the bearings

Extract the old bearings from the pump shaft

Install the new bearings onto the pump shaft

Ensure the pump is turned off and isolated from the power source

Wear suitable personal protective equipment

Is the pump used for liquids that harden or crystallize?

Wash the pump before taking it out of operation if used for hardening or crystallizing liquids

Clean the external parts of the pump and motor to remove dust and deposits

Ensure washing liquids are compatible with the process liquid and the pump

Verify the pump is intended for food product handling.

Select the appropriate cleaning method (CIP or manual disassembly).

Determine the cleaning situations

Chemical and Temperature Selection

Select necessary detergents and concentrations based on food product type.

Determine operating temperatures for cleaning cycle.

Check compatibility of chemical products and operating temperatures with pump components.

Did the pump generate the required discharge head rapidly?

Repeat the priming operations if the required discharge head was not achieved.

Discharge Head and Capacity Check

Is the delivery gate valve opened more than necessary?

Throttle the discharge if the valve is opened more than necessary to achieve required head and capacity.

Is the discharge head greater than required?

Consider reducing the impeller diameter if the discharge head is greater than required.

Is the discharge head lower than required?

Ensure washing liquids are compatible with the process liquid and the pump

Use suitable personal protective equipment during cleaning operations

Has the pump been used for liquids that tend to harden or crystallize?

Run the pump with washing fluids compatible with the pumped fluid and the pump itself

Ensure the pump is washed before taking the machine out of operation

Is the pump ready for disassembly of the pumping parts?