Burton Medical Medical Light ALEDDC

Remove the plastic cap covering the rotating mechanism by pulling it away from the assembly.

Use a common screwdriver to adjust the screw.

Does the lighthead remain balanced when moved slightly up or down at mid-range?

Snap the plastic cap back into position.

Power off the equipment and secure it from being switched on again.

Ensure only approved cleaning agents are used

Use a soft cloth dampened with a mild detergent solution for basic cleaning of all surfaces.

For stubborn stains, use a soft cloth soaked in isopropyl alcohol.

Remove the pods to access the screws holding the housing together.

Remove the screws holding the housing together

Lift the top housing off to access the nuts on each shaft.

Use a wrench to tighten the nuts on each shaft.

Rotate the light head about the shaft to verify correct friction.

Ensure the light is turned off and unplugged

Remove pods to access screws (if applicable)

Remove screws to detach top housing

Use a soft cloth to wipe corners and surfaces

Ensure no components inside the light head are bent or damaged

Ensure the power supply is turned off

Remove the following components

Disconnect the wires for the LED module from the terminal block next to the cooling fan in the center

Install the new LED module in reverse order