Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Bradford White Water Heater RG2PV75H6X19

Create an account to install this asset package.

Maintenance Plans for Bradford White Water Heater Model RG2PV75H6X19

Integrate maintenance plans directly into your work orders in MaintainX.

Anode Inspection

Anode Inspection & Replacement

Take necessary precautions to prevent personal injury

Position on/off switch of gas control valve to the 'OFF' position and unplug water heater from wall outlet

Turn off cold water supply to water heater

Connect hose to drain valve of water heater and route to an open drain

Open a nearby hot water faucet to vent water heater for draining

Open drain valve of water heater and allow water heater to drain to a point below the outlet connection nipple

Disconnect outlet nipple from plumbing system

Remove outlet nipple/anode from the water heater using an appropriate tool such as a pipe wrench

Run this procedure

115 VAC Circuit Testing

115 VAC Circuit Trace

Verify 115 VAC and proper polarity at wall outlet

With unit plugged in and control power switch in the “ON” position verify LED status

Run this procedure

6 Monthly Burner Inspection

Burner Inspection

Check for causes of unstable pilot flame

Inspect pilot flame stability

Inspect main burner flame color and stability

Check for debris accumulation on main burner

Is the main burner free from debris?

Run this procedure

Pressure Switch Testing

Position power switch on gas control to the “OFF” position.

Remove the three screws from control access cover on blower assembly and remove cover.

Remove pressure switch from blower housing

Note any warnings or precautions taken during the procedure.

To resume operation, follow the instructions located on the lighting instruction label or the lighting instructions located in the installation and operation manual.

Run this procedure

Flame Arrestor Cleaning

ScreenLok® Flame Arrestor Cleaning

Is the model equipped with the ScreenLok® Flame Arrestor?

Position Gas Control power switch to the “OFF” position.

Remove outer door.

Remove outer jacket door and inner door per service procedure XIII on page 39.

Disconnect main burner feedline (3/4” wrench), pilot tube (7/16” wrench) and igniter/flame sensor wire from gas control and remove burner assembly from combustion chamber.

Clean ScreenLok® Flame Arrestor using stiff brush, compressed air and/or shop vacuum to remove any scale or other debris accumulation.

Using a soft brush, clear jacket openings from any dirt, dust, restrictions or other obstructions.

Remove any debris from burner assembly per PROCEDURE I and reinstall burner assembly into combustion chamber.

Run this procedure