Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Bradford White Water Heater RG2PV50T6N19

Create an account to install this asset package.

Maintenance Plans for Bradford White Water Heater Model RG2PV50T6N19

Integrate maintenance plans directly into your work orders in MaintainX.

Pilot Inspection

Pilot Inspection, Testing and Replacement

Position gas control power switch to the “OFF” position and unplug heater from wall outlet.

Turn off gas supply to water heater.

Remove outer jacket door and inner door per service procedure XIII on page 39.

Disconnect pilot tubing nut (7/16” wrench) and feedline nut (3/4” wrench) from gas control.

Disconnect igniter/flame sense wire from gas control.

Remove burner assembly from combustion chamber.

Remove pilot assembly from feedline (1/4” nut driver).

Visually inspect igniter/flame sense wire for damage. Replace pilot if damage is found.

Run this procedure

Gas Control Maintenance

ECO (Energy Cut Out)

Reset the gas control after an error code (4)

Turn the gas control knob to the “LOW” position

Wait a minimum of 5 minutes before relighting

Follow the instructions on the lighting instruction label or manual

Gas Control Disassembly/Reassembly

Set the gas control to the “OFF” position

Turn off gas supply to water heater

Disconnect gas supply line from gas control

Run this procedure

Burner Cleaning

Position gas control power switch to the “OFF” position and unplug heater from wall outlet.

Turn off gas supply to water heater.

Remove outer jacket door and inner door per service procedure XIII on page 39.

Disconnect pilot tube (7/16” wrench) and feedline (3/4” wrench) from gas control.

Disconnect igniter/flame sensor wire from gas control.

Remove burner assembly from combustion chamber.

Thoroughly inspect burner surface area and burner port area and remove any loose debris.

Unscrew burner from main burner orifice.

Run this procedure

Pressure Switch Testing

Position power switch on gas control to the “OFF” position.

Remove the three screws from control access cover on blower assembly and remove cover.

Remove pressure switch from blower housing

Note any warnings or potential hazards encountered during the procedure.

To resume operation, follow the instructions located on the lighting instruction label or the lighting instructions located in the installation and operation manual.

Run this procedure

Safety Circuit Voltage Testing

Safety Circuit Voltage Trace

Ensure safety precautions are in place

Remove three screws from control access cover on blower using a Phillips screwdriver

Remove control access cover from blower

Run this procedure