Bradford White Water Heater RG2PV40T6X19

Position gas control power switch to the “OFF” position and unplug heater from wall outlet.

Turn off gas supply to water heater.

Remove outer jacket door and inner door per service procedure XIII on page 39.

Disconnect pilot tube (7/16” wrench) and feedline (3/4” wrench) from gas control.

Disconnect igniter/flame sensor wire from gas control.

Remove burner assembly from combustion chamber.

Thoroughly inspect burner surface area and burner port area and remove any loose debris.

Unscrew burner from main burner orifice.

Position gas control power switch to 'OFF' position and adjust control to call for heat.

Unplug blower power cord from wall outlet.

Disconnect vent system from exhaust adapter on top of blower.

Remove exhaust adapter from blower and retain for use on new blower.

Remove the three blower mounting screws.

Remove blower with gasket from water heater.

Pilot Inspection, Testing and Replacement

Position gas control power switch to the “OFF” position and unplug heater from wall outlet.

Turn off gas supply to water heater.

Remove outer jacket door and inner door per service procedure XIII on page 39.

Disconnect pilot tubing nut (7/16” wrench) and feedline nut (3/4” wrench) from gas control.

Disconnect igniter/flame sense wire from gas control.

Remove burner assembly from combustion chamber.

Remove pilot assembly from feedline (1/4” nut driver).

Visually inspect igniter/flame sense wire for damage. Replace pilot if damage is found.

Gas Control Removal From Water Heater

Position the gas control power switch to the “OFF” position and unplug heater from wall outlet.

Drain the heater to a point below the gas control level.

Turn off the gas supply to the water heater and disconnect gas piping from the gas control.

Disconnect wire harnesses from the gas control.

Remove the outer jacket burner access door.

Remove (2) hex drive screws from RIGHT side inner door.

Remove (2) hex drive screws from FLANGE SECTION of inner door.

Verify 115 VAC and proper polarity at wall outlet

With unit plugged in and control power switch in the “ON” position verify LED status