Bradford White Water Heater RG1PV40S10N19

Position power switch on gas control to the “OFF” position.

Remove the three screws from control access cover on blower assembly and remove cover.

Remove pressure switch from blower housing

Use caution to avoid personal injury due to 115 volt potential exposure.

To resume operation, follow the instructions on the lighting instruction label or the installation and operation manual.

Blower Temperature Switch Testing

Position power switch on gas control to the “OFF” position

Remove the three screws from control access cover on blower and remove cover

Locate blower temperature switch

Verify 115 VAC and proper polarity at wall outlet

With unit plugged in and control power switch in the “ON” position verify LED status

Gas Control Removal From Water Heater

Position the gas control power switch to the “OFF” position and unplug heater from wall outlet.

Drain the heater to a point below the gas control level.

Turn off the gas supply to the water heater and disconnect gas piping from the gas control.

Disconnect wire harnesses from the gas control.

Remove the outer jacket burner access door.

Remove (2) hex drive screws from RIGHT side inner door.

Remove (2) hex drive screws from FLANGE SECTION of inner door.

Position gas control power switch to 'ON' position and adjust control to call for heat.

Remove the three screws from control access cover on blower assembly using a Phillip’s screw driver.

Refer to photo 7 for guidance on removing the cover.